SPOT COAT - Self-adhesive backing foils for spot coating
     
 

The SPOT COAT 50 TR and SPOT COAT TR 50 WM self-adhesive backing foil is 0,50 mm thick, transparent, crystal-clear and designed for use in indirect coating on all offset presses via water damping pans or inking units. The SPOT COAT TR 800 is transparent, thickness is 1,00 mm for the application in offset presses with coating unit.

SPOT COAT TR 800
With a hardness of 85 Shore. The operational area is for simple spots in packaging and simply printings for partial varnishing. This foil is for water base and UV-varnish, the special surface is suitable for both sorts. It is maybe impossible that the ink built up because the surface refuses the ink. The thickness is 0,8 mm within the best relief in use of coating units. The foil can be stuck on an aluminium plate or also on polyester foils, that's opinion of the user. SPOT COAT TR 800 is transparent, so it's possible to cut the sign of the offset plate by seeing through the foil. In use of polyester it is possible to cut on a light table with the use of the film montage, it's easy to cut the spots. We deliver the SPOT COAT TR 800 in rolls of 10 m and in a largeness of 1300 mm. This foil is a solution for an easy and low cost coating plate for partial varnishing

SPOT COAT 50 TR
with a hardness of approximately 115 Shore, but easily cut by hand, the thickness is 0,50 mm. Designed specifically for UV coating, but also suitable for acrylic and printing varnishes. We deliver the SPOT COAT 50 TR in rolls of 10 m and in a largeness of 1300 mm.

SPOT COAT TR 50 WM
with a hardness of 85 Shore, the thickness is 0,50 mm. Excellent cutting properties by hand or on a fleet bed plotter. No burs on the cutting edges which may cause cuts and scores on the application roller or in the blanket. It is designed for use with acrylic varnishes. We deliver the SPOT COAT TR 50 WM in rolls of 10 m and in a largeness of 1150 mm.

Instructions:
The plate making method is the same for both foils, the foils are not copy able. The SPOT COAT foil is to be glued to a clean and grease-free offset aluminium plate. For cutting it is necessary to prepare a printing plate ready for use, attach the foil and cut out the unprinted areas. The design is visible through the transparent foil, resulting in a clean cut true to register. The SPOT COAT TR 50 WM and SPOT COAT TR 800 is also designed for cutting on the fleet bed plotter.


Home I Company Information I Coating plates I Operating instruction I Contact